Courtesy Lamp: Description and Operation

COURTESY/ILLUMINATED ENTRY LAMPS
When the body control module (BCM) is in an active state (awake) it energizes the courtesy lamps supply voltage circuit. The courtesy lamps supply voltage circuit supplies voltage to all of the interior lamps, including the illuminated entry lamps (courtesy lamps). The illuminated entry lamps are turned ON when they receive a battery positive voltage from the courtesy lamp supply voltage circuit of the BCM. When the ignition is in the LOCK position the BCM will apply the courtesy lamp supply voltage circuit under the following conditions:
- The door jamb input transitions to an active state (opening a door).
- The use of the remote keyless entry (RKE) to unlock the side doors.

When the courtesy lamps supply voltage circuit and the courtesy lamp low control circuit are active the courtesy/illuminated entry lamps will illuminate. The courtesy lamps/illuminated entry lamps include the following interior lamps :
- The dome lamp
- The roof rail courtesy lamps
- The I/P courtesy lamps

When the driver uses the remote function actuator transmitter to unlock the doors, the BCM will illuminate the courtesy lamps for approximately 40 seconds, unless another BCM function causes the lamps to remain active. If the ignition switch is turned to either the RUN or START position the courtesy lamps will turn OFF immediately.

When the door latch switch signal circuit is active with the ignition in the OFF position the BCM will illuminate the courtesy lamps. The courtesy lamps will remain illuminated for approximately 25 seconds, after the door latch switch signal circuit becomes inactive, unless another BCM function causes the lamps to remain active. If the ignition switch is turned to either the RUN or START position the courtesy lamps will turn OFF immediately.

I/P COURTESY LAMP
The I/P courtesy lamp is turned ON by the lamp switch assembly or during illuminated entry.

During illuminated entry or when the I/P dimmer switch is DOME the BCM wakes up and then energizes the courtesy lamps supply voltage circuit, suppling voltage to all interior lamps.

ROOF RAIL COURTESY/READING LAMPS
The roof rail courtesy lamps are turned ON by the lamp switch assembly, the individual roof rail courtesy lamp switch, or during illuminated entry.

During illuminated entry or when the I/P dimmer switch is ON the BCM wakes up and then energizes the courtesy lamps supply voltage circuit, suppling voltage to all interior lamps.

The roof rail courtesy/reading lamps can be turned ON from the individual roof rail courtesy lamp switch. The BCM supplies voltage through the courtesy lamps supply voltage circuit when the BCM is awake. Manually turning ON the roof rail courtesy lamp switch provides a ground path.