Without RPO NC1 or NF7

Exhaust Manifold Installation - Right (W/O RPO NC1 or NF7)





1. Notice: Refer to Fastener Notice.

If the engine is equipped with coolant heaters, install the right side (1) heater as follows:
1. Place the coolant heater (1) in position on the cylinder block.
2. Install the coolant heater bolt.
Tighten the coolant heater bolt to 10 Nm (89 inch lbs.).





2. Position a new manifold gasket (1) in place on the cylinder head studs.
3. Using two hands, position the manifold (2) onto the cylinder head.
4. Install two outer manifold nuts (3) to hold the manifold in place.
5. Install the remaining manifold nuts.
Tighten the exhaust manifold nuts (3) to 25 Nm (18 ft. lbs.).





6. Coat the oxygen sensor threads with high temperature anti-seize, GM P/N 12377953 or equivalent.
7. Install the oxygen sensor (1).
Tighten the oxygen sensor to 40 Nm (30 ft. lbs.).





8. Install the exhaust intermediate pipe.





9. Install the exhaust intermediate pipe bolts.
Tighten the exhaust intermediate pipe bolts to 30 Nm (22 ft. lbs.).





10. Install the engine rear lift bracket.
11. Install the engine rear lift bracket bolts.
Tighten the engine rear lift bracket bolts to 30 Nm (22 ft. lbs.).





12. Important: The exhaust gas recirculation (EGR) valve inlet pipe incorporates a crush seal connection at the water crossover. The EGR valve inlet pipe must be replaced if disconnected from the water crossover.

Install the NEW EGR valve inlet pipe into the water crossover port.





13. Loosely thread the EGR valve inlet pipe nut (1) onto the fitting on the exhaust intermediate pipe.





14. Loosely thread the EGR valve inlet pipe bolt into the water crossover.
15. Tighten the EGR valve inlet pipe nut.
Tighten the EGR valve inlet pipe nut to 60 Nm (44 ft. lbs.).
16. Tighten the EGR valve inlet pipe bolt.
Tighten the EGR valve inlet pipe bolt to 28 Nm (21 ft. lbs.).