Knock Sensor: Service and Repair

KNOCK SENSOR (KS) REPLACEMENT

REMOVAL PROCEDURE




1. Remove the intake manifold.
2. Disconnect the electrical connector (3) from the right knock sensor, if required.




3. Disconnect the electrical connector (2) from the left knock sensor, if required.




4. Remove the appropriate knock sensor. Cylinder heads shown removed for clarity.

INSTALLATION PROCEDURE




1. Install the appropriate knock sensor.

NOTE: Refer to Fastener Notice.

Tighten the sensor to 25 N.m (18 lb ft).




2. Connect the electrical connector (2) to the left knock sensor, if required.




3. Connect the electrical connector (3) to the right knock sensor, if required.
4. Install the intake manifold.