12. Input Shaft End Play Measurement

Input Shaft End Play Measurement

^ Tools Required
- J 39686 Input End Play Check Tool
- J 25025-7A Dial Indicator Post
- J 8001 Dial Indicator





1. Rotate the transmission so the side cover (29) faces up.
2. Install the J 39686 into the case barrel. Install the J 25025-7A.





3. Locate the J tab of the J 39686 on the input shaft (604). The arrow on the J tab should have a 90 degree orientation.

4. Important:
The washer of the J 39686 must rest flat on the case cover seal.

Rotate the threaded shaft of the J 39686 clockwise until the shaft is tight. Leave enough space for the collar.
5. Insert the collar. Install the J 8001.





6. Push down on the handle of the J 39686 and check the end play.
End play should be 0.10 - 0.85 mm (0.004 - 0.033 inch).
If the measurement is out of the specification range, determine the appropriate selective thrust washer (522) for installation when you reassemble the input shaft.
7. Remove the J 8001, the J 25025-7A and the J 39686.