Lighting Systems
DTC C0870
Circuit Description
The body control module (BCM) applies a ground through the brake pedal sensor reference low circuit to the BPPS. The BCM supplies a 10-volt reference through the brake pedal sensor reference voltage circuit to the BPPS. When the brake pedal is being applied, the BPPS then sends a variable voltage signal through the brake pedal sensor signal circuit to the BCM.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0870 Brake Pedal Position Sensor Reference Output Circuit
Conditions for Running the DTC
The battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
* A short to ground or an open in the brake pedal position sensor voltage reference circuit is present.
* A short battery positive voltage in the brake pedal position sensor voltage reference circuit is present.
Action Taken When the DTC Sets
The stop lamps will not function correctly.
Conditions for Clearing the DTC
* The DTC will clear on current status after the condition for setting the fault is corrected.
* A history DTC will clear after 100 consecutive ignition cycles without a fault present.
* A History or current DTC can be cleared using a scan tool.
Diagnostic Aids
Perform a visual inspection for loose or poor connections at all related components. refer to Testing for Intermittent Conditions and Poor Connections. Component Tests and General Diagnostics
Test
