138. Exhaust Manifold Installation - Right Side

Exhaust Manifold Installation - Right Side




1. Install a NEW O-ring on the crankshaft position sensor, if damaged.




2. Position the crankshaft position sensor into the cylinder block.

Notice: Refer to Fastener Notice.

3. Install the crankshaft position sensor bolt.

Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).




4. Position the right knock sensor to the cylinder block as shown.
5. Install the knock sensor bolt.

Tighten the knock sensor bolt to 23 N.m (17 lb ft).

6. Ensure proper knock sensor orientation.




7. Install the block heater cartridge, if equipped.




8. Position a NEW exhaust manifold gasket onto the right exhaust manifold.
9. Install the exhaust manifold bolts into the right exhaust manifold.
10. Place the right exhaust manifold, exhaust manifold gasket and bolts as an assembly in position on the right cylinder head.
11. Install the exhaust manifold bolts into the right cylinder head.

Tighten the exhaust manifold bolts to 25 N.m (18 lb ft).




12. Place the right exhaust manifold heat shield in position.
13. Install the exhaust manifold heat shield bolts.

Tighten the exhaust manifold heat shield bolts to 10 N.m (89 lb in).