Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake

CAMSHAFT POSITION ACTUATOR SOLENOID VALVE SOLENOID REPLACEMENT - BANK 2 (LEFT SIDE) INTAKE

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access.

IMPORTANT: Do not disconnect the power steering fluid lines/hoses from the reservoir.




3. Remove the camshaft position (CMP) actuator valve electrical connector.




4. Remove the CMP actuator valve bolt.
5. Remove the CMP actuator valve.

INSTALLATION PROCEDURE




1. Install the CMP actuator valve.
2. Install the CMP actuator valve bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the CMP actuator valve bolt to 10 Nm (89 lb in).




3. Install the CMP actuator valve electrical connector.
4. Install the power steering fluid reservoir.