Turn Signal Switch Housing Replacement

Turn Signal Switch Housing Replacement

Removal Procedure





Caution: Refer to Restraint System Service Precautions in Service Precautions.

1. Disable the SIR system.
2. Remove the tilt head components.
3. Remove the turn signal and multifunction switch assembly only.
4. Slide the turn signal switch housing off of the steering column shaft assembly.

Installation Procedure





Important: The switch mounting bracket must be pressed firmly against the steering column tilt head.

1. Slide the turn signal switch housing onto the steering column shaft assembly.
2. Install the turn signal and multifunction switch assembly only.
3. Install the tilt head components.
4. Enable the SIR system.