Quarter Window Replacement

Quarter Window Replacement

Tools Required
* J 39032 Stationary Glass Removal Tool
* Urethane Adhesive Kit GM P/N 12346392 or Equivalent
* Isopropyl Alcohol or Equivalent
* Cartridge-type Caulking Gun
* Commercial-type Utility Knife
* Razor Blade Scraper
* Suction Cups
* Plastic Paddle

Removal Procedure






Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.

1. Remove the rear quarter upper trim.
2. Remove the rear quarter lower trim.

Caution: refer to Glass and Sheet Metal Handling Caution.

Important: Keep the cutting edge of the tool against the window. Do this from inside the vehicle to protect the outer painted surface.

3. This will allow the urethane adhesive to be separated from the window:

* Leave a base of urethane on the pinch-weld flange.
* The only suitable lubrication is clear water.
* Use J 39032 or equivalent in order to remove the window.
* Remove the quarter modular window from the pinch-weld flange.

Installation Procedure

1. Install a stationary window into the opening. refer to Urethane Adhesive Installation of Heated Glass Element.
2. Install the rear quarter lower trim.
3. Install the rear quarter upper trim panel.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.