Front Side Door Lock Replacement

Front Side Door Lock Replacement

Removal Procedure




1. Remove the front door trim panel.
2. Remove the front door water deflector.

Important: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.

When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.

3. Open the outside handle rod to lock clip located on the door lock.
The outside handle rods should be loose from the lock.
4. the lock cylinder rod from the outside door handle.





Important: Do not attempt repairs in order to correct lock discrepancies. Replace the lock.

5. the screws from door lock.
6. the door lock and cable through the access hole in the door inner panel.
7. Disconnect the electrical connector from the lock.
8. the lock and cable from the door.

Installation Procedure

1. Install the lock and cable to the door.
2. Connect the electrical connector to the lock.
3. Install the lock and cable through the access hole in the door inner panel.





Notice: refer to Fastener Notice.

4. Install the screws to the door lock.

Tighten the screws to 10 N.m (89 lb in).

5. Install the lock cylinder rod to the outside door handle.




6. Install the outside handle rod into the clip.
7. Close the clip over the outside handle rod.
8. Install the inside door handle. Refer to LINK.
9. Inspect the door for proper operation.
10. Install the front door water deflector.
11. Install the front door trim panel.