Oil Pan: Service and Repair

Oil Pan Replacement

Removal Procedure




1. Disconnect the negative battery cable.
2. Remove the fuel injector sight shield.
3. Remove the air cleaner intake duct.
4. Install the engine support fixture.
5. Raise and support the vehicle.
6. Drain the engine oil and remove the oil filter.
7. Remove the power steering oil cooler pipe brackets from the frame.
8. Disconnect the oil level sensor electrical connector (10).
9. Remove the oil level sensor wiring harness bolt and reposition the oil level sensor wiring harness.




10. Remove the catalytic converter (3) to the right exhaust manifold pipe stud nuts (2) and reposition the catalytic converter.
11. Remove the left engine mount strut.
12. Remove the right engine mount strut.
13. Remove the torque converter covers.
14. Lower the vehicle.
15. Using the engine support fixture raise the engine to gain access for the oil pan removal.
16. Raise the vehicle.

Notice: Remove the oil level sensor, located in the oil pan, before the oil pan is removed. The sensor may be damaged if the oil pan is removed first.




17. Remove the oil level sensor.




18. Remove the oil pan bolts.
19. Remove the oil pan.




20. Remove the oil pump pipe screen assembly and the oil pan gasket.
21. Clean the following parts:
* Oil pump screen mating surfaces
* Oil pan flanges
* Oil pan rail
* Front cover
* Rear main bearing cap
* Threaded holes

Installation Procedure




1. Install the oil pan gasket and the oil pump pipe screen assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the oil pump pipe screen bolts.

Tighten the bolts to 15 N.m (11 lb ft).

Notice: Install the oil level sensor, located in the oil pan, after the oil pan is installed. The sensor may be damaged if the oil level sensor is installed first.




3. Install the oil pan.
4. Clean the oil pan bolts and apply one drop of threadlock compound to the oil pan bolt threads.
5. Install the oil pan bolts.

Tighten the oil pan bolts to 14 N.m (125 lb in).




6. Install the oil level sensor.

Tighten the sensor to 20 N.m (15 lb ft).

7. Install the torque converter covers.
8. Install the engine mount and the engine mount bracket.




9. Install the catalytic converter (3) to the right exhaust manifold.
10. Install the catalytic converter pipe stud nuts (2).

Tighten the nuts to 32 N.m (24 lb ft).

11. Install the oil level sensor wiring harness and the oil level sensor wiring harness bolt to the engine.

Tighten the bolt to 10 N.m (89 lb in).




12. Connect the oil level sensor electrical connector (10).
13. Install the power steering oil cooler pipe brackets to the frame.
14. Install the engine oil filter.
15. Lower the vehicle.
16. Remove the engine support fixture.
17. Install the right engine mount strut.
18. Install the left engine mount strut.
19. Fill the crankcase with engine oil.
20. Install the air cleaner intake duct.
21. Install the fuel injector sight shield.
22. Connect the negative battery cable.
23. Inspect for leaks.