B3125

DTC B3125

DTC DESCRIPTOR

DTC B3135 00

All Door Lock Circuit

DIAGNOSTIC FAULT INFORMATION






IMPORTANT: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

CIRCUIT/SYSTEM DESCRIPTION
When the door lock switch is place in to the LOCK position, ground is applied through the switch to the body control module (BCM). The BCM then applies a voltage through the door lock relay control circuit to the coil side of the lock relay in the body electrical center (BEC). The relay then engages and applies voltage to all the door lock assemblies.

CONDITIONS FOR RUNNING THE DTC
The ignition is ON.

CONDITIONS FOR SETTING THE DTC
The BCM receives a ground signal on the door lock relay control circuit

ACTION TAKEN WHEN THE DTC SETS
The BCM cease attempt to lock the doors.

CONDITIONS FOR CLEARING THE DTC
The BCM clears this code from current when the fault is removed from the system.