Keyless Entry Transmitter Battery: Service and Repair

Transmitter Battery Replacement

Removal Procedure

1. Replace the batteries when the range of the transmitter decreases to less than 7 m (23 ft).




2. Insert a small coin between the two halves of the transmitter case at the slot provided near the key ring hole.
3. Twist the coin in order to open the case.
4. Open the transmitter case.




5. Remove the battery (2).

Installation Procedure




1. Install the battery (2) with the positive (+) side down.
Use one 3 V CR2032 battery (or the equivalent).
2. Close the transmitter case (6, 4).




3. Ensure that the seal is in position. Align the two halves of the case and snap the two halves together.
4. Reprogram the transmitter. Refer to Transmitter Programming. Programming and Relearning