Operation CHARM: Car repair manuals for everyone.

Oil Level Sensor: Service and Repair



Engine Oil Level Sensor and/or Switch Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the oil pan drain plug and allow the oil to drain.




3. Disconnect the engine harness electrical connector (2) from the oil level sensor.




4. Remove the oil level sensor.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the oil level sensor.

Tighten the sensor to 20 N.m (15 lb ft).




2. Connect the engine harness electrical connector (2) to the oil level sensor.




3. Install the oil pan drain plug.

Tighten the plug to 30 N.m (22 lb ft).

4. Lower the vehicle.
5. Fill the crankcase with engine oil. Refer to Capacities - Approximate Fluid.