4T80-E - Automatic Transaxle

Vehicle Speed Sensor Replacement

Removal Procedure

1. Raise the vehicle. Refer to Vehicle Lifting.




2. Remove the bolts (1, 3) securing the front transaxle brace (2) to the transaxle and right cylinder head.
3. Remove the electrical connector at the vehicle speed sensor.




4. Remove the retaining bolt (131) and the sensor (130). Twisting the sensor while pulling outward will aid in removal.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.




1. Install the vehicle speed sensor (130) and the retaining bolt (131). Install a new O-ring seal on sensor if necessary.

Tighten the bolt to 10 N.m (89 lb in).

2. Install the electrical connector at the sensor.




3. Install the bolts (1, 3) securing the front transaxle brace (2) to the transaxle and right cylinder head.
4. Lower the vehicle.