Steering Wheel: Service and Repair

Steering Wheel Replacement

Tools Required

* J 42578 Steering Wheel Puller Legs
* J 1859-A Steering Wheel Puller

Removal Procedure





Caution: Refer to Restraint System Service Precautions in Service Precautions.

1. Disable the SIR system.
2. Remove the Inflatable restraint steering wheel module.
3. Disconnect the steering wheel electrical connector.
4. Remove the weight block from the steering wheel base, if equipped.
5. Remove the steering wheel retaining nut.
6. Note the mark on the steering shaft and the steering wheel in order to ensure proper alignment during installation.




7. Install J 42578 and J 1859-A to the steering wheel.
8. Use J 42578 and J 1859-A to separate the steering wheel from the steering column.
9. Remove the steering wheel from the steering column.
10. Remove the J 42578 and J 1859-A from the steering wheel.

Installation Procedure




1. Route the wiring through the steering wheel.
2. Align the mark on the steering wheel with the mark on the shaft.
3. Install the steering wheel.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the steering wheel retaining nut.

Tighten the nut to 41 N.m (30 lb ft).

5. Install the weight block to the steering wheel if equipped.
6. Connect the steering wheel electrical connector.
7. Install the inflatable restraint steering wheel module.
8. Enable the SIR system.