Power Steering Pump Pulley Replacement

Power Steering Pulley Replacement (RPO LD8)

Tools Required

- J 25034-C Pulley Remover
- J 25033-C Pulley Installer

Removal Procedure




1. Remove the drive belt.
2. Install a drain pan under the vehicle.
3. Disconnect the power steering return hose from the power steering reservoir.
4. Remove the power steering pump mounting bolt.




5. Raise the power steering pump up to access the power steering pulley.
6. Use the J 25034-C to remove the power steering pulley.

Installation Procedure

1. Use the J 25033-C to install the power steering pulley to the pump.




2. Position the power steering pump to the engine.

Notice: Refer to Fastener Notice.

3. Install the power steering pump mounting bolt.

Tighten the power steering pump mounting bolt to 50 N.m (37 lb ft).




4. Install the power steering return hose to the power steering reservoir.
5. Remove the drain pan from under vehicle.
6. Install the drive belt.
7. Bleed the power steering system.