OSS Sensor and Cooler Fitting Installation

OSS Sensor and Cooler Fitting Installation




1. Inspect the output speed sensor (130) for damage or a cut seal (4).
2. Inspect the cooler connector (3) for damaged threads, clogging, or a cut seal (4).




3. Install the output speed sensor (130) and the seal (4).

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the output speed sensor bolt (131).

Tighten the bolt to 8-14 N.m (6-10 lb ft).

5. Install the cooler fitting (3) and the new seal (4) or fitting (38) and seal (39) into the case.

Tighten the cooler fitting to 25-29 N.m (19-21 lb ft).