94. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Tools Required
* J 37096 Flywheel Holder
* J 45059 Angle Meter




1. Lubricate the seal surface of the crankshaft balancer with engine oil.

Important: The crankshaft position sensor system variation learn procedure must be completed whenever the crankshaft is replaced.


2. Install the crankshaft balancer.
3. Use J 37096 to hold the flywheel.





Notice: Refer to Special Fastener Notice (Special Fastener Notice).

Notice: Refer to Fastener Notice.

4. Install the crankshaft balancer bolt.

Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft). Use J 45059 to tighten the crankshaft balancer bolt an additional 76 degrees.