Oil Level Sensor: Service and Repair

Engine Oil Level Sensor and/or Switch Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the engine oil drain plug in order to drain the engine oil.




3. Disconnect the oil level sensor electrical connector.
4. Remove the engine oil level sensor from the oil pan.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the engine oil level sensor to the oil pan.

Tighten the sensor to 20 N.m (15 lb ft).

2. Connect the oil level sensor electrical connector.




3. Install the engine oil drain plug.

Tighten the plug to 30 N.m (22 lb ft).

4. Lower the vehicle.
5. Fill the crankcase with engine oil. Refer to Engine Oil and Oil Filter Replacement (Service and Repair).