Cooling Fan Always On
Cooling Fan Always On
Circuit/System Description
The engine cooling fan system consists of 2 electrical cooling fans and 3 fan relays. The relays are arranged in a series/parallel configuration that allows the engine control module (ECM), or powertrain control module (PCM), to operate both fans together at low or high speeds. The cooling fans receive positive voltage from the cooling fan relays which receive battery positive voltage from the underhood fuse block.
During low speed operation, the ECM or PCM supplies the ground path for the low speed fan relay, which is fan 1 relay 42, through the low speed cooling fan relay control circuit. This energizes the low speed fan relay coil, closes the relay contacts, and supplies battery positive voltage from the fan 1 fuse 29 through the cooling fan motor supply voltage circuit to the left cooling fan. The ground path for the left cooling fan is through the series/parallel relay, which is fan 2 relay, and the right cooling fan. The result is a series circuit with both fans running at low speed.
During high speed operation the ECM or PCM supplies the ground path for the low speed fan relay through the low speed cooling fan relay control circuit. The ECM or PCM grounds the high speed fan relay, which is fan 3 relay 43, and the series/parallel relay through the high speed cooling fan relay control circuit. This energizes the series/parallel relay coil, closes the relay contacts, and provides a ground path for the left cooling fan. At the same time the high speed fan relay coil is energized closing the relay contacts and provides battery positive voltage from the fan 2 fuse 32 on the cooling fan motor supply voltage circuit to the right cooling fan. During high sped fan operation, both engine cooling fans have their own ground path. The result is a parallel circuit with both fans running at high speed.
Reference Information
Schematic Reference
Engine Cooling Schematics (Electrical Diagrams)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Cooling Fan Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
1. Verify that DTCs P0480, P0481, P0691, P0692, P0693 and P0694 are not set.
• If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (Diagnostic Trouble Code Descriptions).
2. Ignition ON, verify with a scan tool that the ECM or PCM is not commanding fan activation.
3. Ignition ON, observe that the fans are not activated.
Circuit/System Testing
Important: You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
1. Ignition OFF, leave the series/parallel relay, which is fan 2 relay 46, in place while disconnecting the other relays.
2. Ignition ON, observe that the fans are not activated.
• If the fans are not activated, replace the faulty relay.
• If a fan is activated, test the fan voltage supply circuits for a short to voltage.
Repair Instructions
* Underhood Electrical Center or Junction Block Replacement (Underhood Electrical Center or Junction Block Replacement)
* Relay Replacement (Attached to Wire Harness) (Relay Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (Relay Replacement (Within an Electrical Center))
Repair Verification
1. Ignition ON, verify with a scan tool that the control module is not commanding fan activation.
2. Ignition ON, observe that the fans are not activated.