Operation CHARM: Car repair manuals for everyone.
Home >> Buick >> 2008 >> LaCrosse V8-5.3L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Engine Control Module >> Testing and Inspection >> Engine Control Module Programming and Setup

Engine Control Module Programming and Setup



Engine Control Module Programming and Setup (5.3L)

The following service procedures require either a programming or a setup event performed for a complete repair.

ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

1. ECM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning).
2. The CKP System Variation Learn-Refer to Crankshaft Position System Variation Learn (Programming and Relearning).
3. Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.
4. Transmission Fluid Life Remaining-When available, use the scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.
5. Theft Deterrent-Refer to Immobilizer System Component Programming (Canada) (Programming and Relearning)Immobilizer System Component Programming (North America except Canada) (Programming and Relearning).

ECM Reprogramming

* If the ECM needs to be reprogrammed, refer to Service Programming System (SPS) (Programming and Relearning).
* Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.

Important: After programming, perform the following to avoid future misdiagnosis:


* Turn the ignition OFF for 30 seconds.
* Turn the ignition ON with the engine OFF.
* Use the scan tool in order to retrieve history DTCs from all modules.
* Clear all history DTCs.

Setup for Component Replacement

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the CKP Variation Learn Procedure must be performed. Refer to Crankshaft Position System Variation Learn (Programming and Relearning).

* Engine replacement
* Any engine repair that disturbs the CKP sensor or its relationship with the crankshaft reluctor wheel
* CKP sensor

pro multis · About Operation CHARM