Rear Suspension

Knuckle Replacement

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).




3. Scribe the strut to the knuckle.
4. Remove the bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (Rear Suspension).
5. Remove the rear wheel spindle rods from the knuckle. Refer to Spindle Rod Replacement (Service and Repair).




6. Remove the trailing arm (2) from the knuckle (3). Refer to Trailing Arm Replacement (Service and Repair).




7. Remove the rear strut to knuckle bolts (2) and the nuts (1). Refer to Strut Assembly Replacement (Strut Assembly Replacement).
8. Remove the knuckle (5) from the vehicle.

Installation Procedure




1. Install the knuckle to the vehicle.
2. Hand start the strut to knuckle bolts (2) and nuts (1). Do not tighten the nuts at this time.




3. Connect the rear suspension trailing arm (2) to the knuckle (3). Refer to Trailing Arm Replacement (Service and Repair).




4. Connect the rear wheel spindle rods to the knuckle. Refer to Spindle Rod Replacement (Service and Repair).
5. Install the bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (Rear Suspension).

Notice: Refer to Fastener Notice (Fastener Notice).

6. Tighten the strut to knuckle bolts (2) and nuts (1).

Tighten bolts to 120 N.m (89 lb ft).

7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
8. Lower the vehicle.
9. Inspect the rear wheel alignment, adjust if necessary. Refer to Wheel Alignment Measurement (Service and Repair).