Steering Mounted Controls Assembly: Service and Repair

Steering Wheel Control Switch Assembly Replacement

Removal Procedure

Caution: Refer to SIR Caution (SIR Caution) .
1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) .
2. Remove the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement) .




3. Remove the retaining screws (1) from the steering wheel bezel.
4. Remove the steering wheel bezel (2).




5. Insert a small, blunt ended tool into the access hole in the back of the steering wheel in order to push the switch out of the steering wheel.
6. Disconnect the electrical connector.


Installation Procedure




1. Connect the electrical connector.
2. Align the switch to the switch opening in the steering wheel.
3. Snap the switch into the steering wheel.




4. Install the steering wheel bezel (2).

Notice: Refer to Fastener Notice.

5. Install the retaining screws (1) to the steering wheel bezel.

Tighten screws to 3 N.m (27 lb in).

6. Install the steering wheel. Refer to Steering Wheel Replacement (Steering Wheel Replacement) .
7. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) .