Tie Rod End: Service and Repair

Rack and Pinion Outer Tie Rod End Replacement

Tools Required

J 24319-B Universal Steering Linkage Puller

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).




3. Remove the lock nut (3) from the outer tie rod (1).




4. Loosen the jam nut (2) on the inner tie rod (1).




5. UsingJ 24319-B remove the outer tie rod from the steering knuckle.




6. Remove the outer tie rod (3) from the inner tie rod (1).


Installation Procedure




1. Install the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).




2. Install the outer tie rod (1) to the steering knuckle (2).





Notice: Refer to Fastener Notice.

3. Install the outer tie rod lock nut (3).

Tighten the tie rod lock nut to 30 N.m (22 lb ft) plus an additional 180 degrees.

4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
5. Lower vehicle.
6. Adjust the toe alignment. Refer to Front Toe Adjustment (Service and Repair).