Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Special Tools

J 41712 Oil Pressure Sensor Socket

Removal Procedure




1. If necessary, remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (Service and Repair).
2. Disconnect the oil pressure sensor electrical connector (4).




3. Using J 41712 , remove the oil pressure sensor (706) and washer (707).

Installation Procedure




1. Apply sealant to the threads of the oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers (Specifications).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Using J 41712 , install the oil pressure sensor (706) and washer (707).

Tighten the sensor to 35 Nm (26 lb ft).




3. Connect the oil pressure sensor electrical connector (4).
4. If necessary, install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (Service and Repair).