95. Engine Prelubing

Engine Prelubing

Special Tools

J 45299 - Engine Preluber

For equivalent regional tools, refer to Special Tools (Special Tools).





Note: A constant/continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil.

1. Remove the engine oil filter, fill with clean engine oil.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the oil filter and tighten to 30 Nm (22 lb ft).
3. Locate the oil pressure sensor on left side of engine and remove.
4. Install the 1/4 inch adapter P/N 509373.




5. Install the flexible hose to the adapter and open the valve.
6. Pump the handle on J 45299 - preluber to flow a minimum of 1-2 quarts of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
7. Close the valve and remove the flexible hose and adapter from the engine.
8. Install the oil pressure sensor and tighten to 16 Nm (12 lb ft).
9. Top off the engine oil to the proper level.