Ignition Lock Cylinder Case Replacement

Ignition Lock Cylinder Case Replacement

Removal Procedure




Warning: Refer to SIR Warning (SIR Warning).

1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).
2. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Ignition Lock Cylinder Replacement).
3. Remove the ignition switch. Refer to Ignition and Start Switch Replacement (Service and Repair).
4. Remove the steering column tilt head components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).
5. Remove the turn signal switch housing. Refer to Turn Signal Switch Housing Replacement (Turn Signal Switch Housing Replacement).
6. Remove the turn signal and multifunction switch assembly only. Refer to Turn Signal Multifunction Switch Replacement (Turn Signal Multifunction Switch Replacement).




7. Remove the park lock cable assembly (1) from the ignition lock cylinder case in the following way:

1. Use a small blade to push against the locking tab on the end of the park lock cable assembly (1).
2. Disconnect the park lock cable assembly (1) from the ignition lock cylinder case.




8. Remove the 3 TORX(R) screws (2) from the ignition lock cylinder case (1).
9. Remove the ignition lock cylinder case (1) from the steering column tilt head assembly.

Installation Procedure




1. Align the ignition lock cylinder case (1) with the steering column tilt head assembly.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Screw the 3 TORX(R) screws (2) into the ignition lock cylinder case (1).

Tighten the 3 TORX(R) screws to 7 Nm (62 lb in).




3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.





Note: Press the turn signal switch housing firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly to align.

4. Install the turn signal switch housing. Refer to Turn Signal Switch Housing Replacement (Turn Signal Switch Housing Replacement).
5. Install the turn signal and multifunction switch assembly only. Refer to Turn Signal Multifunction Switch Replacement (Turn Signal Multifunction Switch Replacement).
6. Install the steering column tilt head components. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).
7. Install the ignition switch only. Refer to Ignition and Start Switch Replacement (Service and Repair).
8. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement (Ignition Lock Cylinder Replacement).
9. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair).