Front Side Door Window Belt Outer Sealing Strip Replacement
Front Side Door Window Belt Outer Sealing Strip Replacement
Removal Procedure
Caution: Refer to Paint Damage Caution (Paint Damage Caution).
1. Apply masking tape to the door and applique.
2. Lower the window to the full down position.
3. Remove the outside rearview mirror. Refer to Power Mirror Replacement (Power Mirror Replacement).
4. Remove the outer belt sealing strip screw (2) located at the rear of the door.
5. Release the front outer belt sealing strip retaining clip, by inserting a suitable flat-bladed tool to the front edge and lift upward.
6. Remove the outer belt sealing strip from the door.
Installation Procedure
Note: When installing the outer belt sealing strip align the molding to the holes properly before pressing the front into place.
1. Install the outer belt sealing strip to the door.
1. Insert the retaining clip for the outer belt sealing strip into the front hole of the door and push down firmly to lock in place.
2. Install the outer belt sealing strip to pinch-weld flange.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the outer belt sealing strip screw (2).
Tighten the screw to 2 Nm (18 lb in).
3. Install the outside rearview mirror. Refer to Power Mirror Replacement (Power Mirror Replacement).
4. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement (Service and Repair).
5. Inspect the window for proper operation.
6. Remove the masking.