Rear Side Door Window Outer Sealing Strip Replacement

Rear Side Door Window Outer Sealing Strip Replacement

Removal Procedure





Caution: Refer to Paint Damage Caution (Paint Damage Caution).

1. Apply masking tape to the door frame and applique.
2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Service and Repair).
3. Lower the window to the full down position.

Note: Lift upward on the sealing strip at the front edge of the rear door stationary window to prevent damage to the sealing strip.

4. Remove the outer belt sealing strip screw.




5. Release the outer belt sealing strip clip, by inserting a suitable flat-bladed tool to the rear edge and lift upward.
6. Remove the outer belt sealing strip from the door.

Installation Procedure




1. Install the outer belt sealing strip to the door.
Insert the retaining clip for the outer belt sealing strip into the rear hole of the door and push down firmly to lock in place.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the outer belt sealing strip screw.

Tighten the screw to 2 Nm (18 lb in).

3. Remove the masking tape.
4. Inspect the window for proper operation.
5. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Service and Repair).