77. Water Crossover Disassemble

Water Crossover Disassemble




1. Remove the water pump cover bolt and studs.
2. Remove the water pump cover.




3. Remove the water outlet bolts.
4. Remove the water outlet and thermostat.
5. Remove and discard the water pump cover gasket.




6. Remove the EGR bracket shield nut.
7. Remove the EGR bracket shield.




8. Remove the EGR valve bolts.
9. Remove the EGR valve.
10. Remove and discard the EGR gasket.




11. Remove the EVAP emission canister purge valve bolts.
12. Remove the EVAP emission canister purge valve.




13. Remove the throttle body bolts.
14. Remove the shift cable bracket.
15. Remove the throttle body.
16. Remove and discard the throttle body seal.




17. Remove the MAP sensor bracket bolt.
18. Remove the MAP sensor bracket.
19. Remove the MAP sensor.




20. Remove the engine coolant outlet fitting.
21. Remove the rear lift bracket bolt.
22. Remove the rear lift bracket.




23. Loosen the throttle body plenum duct clamp.
24. Remove and discard the throttle body plenum duct.




25. Remove the water pump bolts.
26. Remove the water pump.




27. Remove and discard the water pump O-ring.