Object Detection
DTC B1395
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC B1395 02
- Control Module Voltage Reference Output Circuit Short to Ground
DTC B1395 03
- Control Module Voltage Reference Output Circuit Low Voltage
DTC B1395 07
- Control Module Voltage Reference Output Circuit High Voltage
Diagnostic Fault Information
Circuit/System Description
The parking assist indicator is located in the interior rear of the vehicle. The indicator contains three LEDs: two amber and one red. The parking assist control module controls these three LEDs as a visual indicator of how close the vehicle bumper is to an object. The parking assist control module supplies voltage to each of the LEDs and commands each LED on by supplying an individual ground.
Conditions for Running the DTC
* Ignition ON
* Transmission in REVERSE
Conditions for Setting the DTC
B1395 02
The parking assist control module has detected a short to ground.
B1395 03
The parking assist control module detects the sensor reference voltage out of range. The reference voltage is less than 9V.
B1395 07
The parking assist control module detects the sensor reference voltage out of range. The reference voltage is greater than 13V.
Action Taken When the DTC Sets
* The parking assist is disabled.
* The driver information center displays SERVICE PARK ASSIST.
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present.
Reference Information
Schematic Reference
Object Detection Schematics ([1][2]Collision Avoidance and Parking Assist Systems)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Object Detection Description and Operation (UVC) (Object Detection Description and Operation (UVC))Object Detection Description and Operation (UD7 with Parking Assist Indicator) (Object Detection Description and Operation (UD7 with Parking Assist Indicator))Object Detection Description and Operation (UFT) (Object Detection Description and Operation (UFT))Object Detection Description and Operation (UD7 without Parking Assist Indicator) (Object Detection Description and Operation (UD7 without Parking Assist Indicator))Object Detection Description and Operation (Accessory Dealer Installed ) (Object Detection Description and Operation (Accessory Dealer Installed ))
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing For Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning)
Circuit/System Verification
Ignition ON, perform the scan tool LED Test. Each of the three LEDs should illuminate during the test cycle.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the P24 Park Assist Display.
2. Ignition ON, test for 9-13V between the B+ circuit terminal A and ground.
• If less than the specified range, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K41 Parking Assist Control Module.
• If greater than the specified range, test the B+ circuit for a short to voltage. If the circuit tests normal, replace the K41 Parking Assist Control Module.
3. If all circuits test normal, replace the P24 Park Assist Display.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Rear Object Alarm Indicator Replacement (Service and Repair)
* Control Module References (Programming and Relearning)for parking assist control module replacement, setup and programming