B2745

DTC B2745

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC B2745 02
- Traction Control Switch Circuit Short to Ground

Diagnostic Fault Information





Circuit/System Description

The body control module (BCM) monitors the traction control switch. When the traction control switch is pressed once, the BCM will request the electronic brake control module (EBCM) via serial data to disable the traction control. When the traction control switch is pressed for 5 s, the BCM will request the EBCM to disable the stability control. The EBCM will request the instrument cluster via serial data to turn the traction control off and stability control off indicator ON to notify the driver of the deactivation.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

The BCM detects a short to ground on the signal circuit.

Action Taken When the DTC Sets

The BCM ignores the traction control switch signal input.

Conditions for Clearing the DTC

A current DTC clears when the diagnostic runs and passes.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing For Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Observe the scan tool BCM Traction Control Switch parameter while pressing and releasing the traction control switch. The reading should change between Active and Inactive.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the S48E Multi-Function Switch Module - Center Console.
2. Test for less than 5 ohm between the ground circuit terminal 2 and ground.

• If greater than the specified value, test the ground circuit for an open/high resistance.

3. Ignition ON, verify the scan tool BCM Traction Control Switch parameter is Inactive.

• If not the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the K9 Body Control Module.

4. Install a 3 A fused jumper wire between the signal circuit terminal 7 and ground.
5. Verify the scan tool BCM Traction Control Switch parameter is Active.

• If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.

6. If all circuits test normal, test or replace the S48E Multi-Function Switch Module - Center Console.

Component Testing

Static Test
1. Ignition OFF, disconnect the harness connector at the S48E Multi-Function Switch Module - Center Console.
2. Test for infinite resistance between the signal circuit terminal 7 and the ground circuit terminal 2 with the switch in the open position.

• If less than the specified value, replace the S48E Multi-Function Switch Module - Center Console.

3. Test for less than 5 ohm between the signal circuit terminal 7 and the ground circuit terminal 2 with the switch in the closed position.

• If greater than the specified value, replace the S48E Multi-Function Switch Module - Center Console.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Accessory Switch Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for BCM replacement, setup and programming