C0161

DTC C0161

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0161 5A
- Antilock Braking System Brake Switch Circuit Not Plausible

Diagnostic Fault Information





Circuit/System Description

The body control module (BCM) monitors the brake pedal position sensor and sends a serial data message when the brake pedal is applied. When the vehicle is stopping, the electronic brake control module (EBCM) monitors for the brake pedal applied serial data message from the BCM, with the brake pressure increasing and the vehicle slowing down, or when the vehicle is accelerating, the brake pedal is not applied and brake pressure is not increasing.

Conditions for Running the DTC

* Ignition ON.
* DTC C0131 is not present.

Conditions for Setting the DTC

* The EBCM detects brake pedal is not applied and the brake pressure is greater 15 bar (218 PSI) for 2 s.
* The EBCM detects the vehicle speed is greater than 16 km/h (10 MPH), the brake pedal is applied for 122 s, and brake pressure is less than 6.2 bar (90 PSI).

Action Taken When the DTC Sets

The EBCM disables the hill start assist for the duration of the ignition cycle.

Conditions for Clearing the DTC

* A current DTC clears when the diagnostic runs and passes.
* The EBCM will turn OFF the indicator in the next ignition cycle.

Diagnostic Aids

The DTC C0161 5A can be set if the brake pedal is applied while accelerating or the brake pedal position sensor is out of adjustment.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing For Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning)

Circuit/System Verification

1. Ignition ON, verify that DTC C0277 is not present in the BCM.

• If DTC C0277 is present, refer to DTC C0277 or C0890 (C0277).

2. Ignition ON, observe the stop lamps while applying and releasing the brake pedal. Verify the stop lamps operate properly.

• If the stop lamps do not operate properly, refer to Symptoms - Lighting (Symptoms - Lighting).

Circuit/System Testing

Replace the K17 Electronic Brake Control Module (EBCM) and verify the DTC does not reset.

If the DTC resets replace the K9 Body Control Module.

Repair Instructions

* Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Control Module References (Programming and Relearning)