Battery Current Sensor: Service and Repair

Battery Current Sensor Replacement (V6)

Removal Procedure




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).
2. Disconnect the body harness electrical connector (2) from the battery current sensor.
3. Remove the negative battery cable frame ground ring terminal nut (3) and detach the negative battery ring terminal.




4. Detach the battery current sensor (2) from the current sensor bracket (3).
5. Slide the sensor from the negative battery cable (1).

Installation Procedure




1. Slide the NEW battery current sensor (2) up onto the battery cable (1).
2. Attach the sensor to the battery current sensor bracket (3).




3. Install the negative battery cable frame ground and tighten nut (3) to 25 Nm (18 lb ft).
4. Connect the body harness electrical connector (2) to the battery current sensor.