35. Reverse Clutch Housing and Second Sprag Disassemble

Reverse Clutch Housing and Second Sprag Disassemble

Special Tools

J 39694 - Spring Compressor

For equivalent regional tools, refer to Special Tools (4T80-E - Automatic Transmission).




1. Remove the spiral snap ring (519). Discard the snap ring, which is not reusable.
2. Remove the following parts:

* The sprag clutch retainer (518)
* The second sprag outer race
* The second sprag clutch (516-517)
* The second sprag outer race thrust washer (520)




3. Remove the following parts:

* The reverse clutch snap ring (515)
* The reverse clutch backing plate (512)
* All of the fiber (513) and steel (511) clutch plates
* The reverse clutch waved plate (514)




4. Install the J 39694 - spring compressor spring compressor and compress the spring and retainer assembly (509). Then remove the snap ring (510).




5. Remove the following parts:

* The snap ring retainer (509)
* The spring and retainer assembly (508)
* The piston assembly (505)