Engine Oil: Service and Repair

Engine Oil and Oil Filter Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Description and Operation).
2. Position the oil drain pan under the engine oil drain plug.




3. Remove the engine oil drain plug.
4. Clean and inspect the engine oil drain plug, replace if necessary.
5. Clean and inspect the engine oil drain plug sealing surface on the oil pan, repair or replace oil pan if necessary.




6. Remove the oil filter.
7. Clean and inspect the oil filter sealing area on the oil filter adapter, repair or replace if necessary.

Installation Procedure

1. Fill the oil filter with oil.
2. Lightly oil the replacement oil filter gasket with clean oil.





Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the new oil filter.

Tighten the new oil filter to 3/4 to 1 full turn, after the oil filter gasket contacts the oil filter mounting surface.




4. Install the engine oil drain plug.

Tighten the engine oil drain plug to 20 Nm (15 lb ft).

5. Lower the vehicle.
6. Fill the engine with new engine oil. Refer to Approximate Fluid Capacities ([1][2]Maintenance) and Fluid and Lubricant Recommendations (USA and Canada) (Maintenance).
7. Inspect for oil leaks after engine start up.