Automatic Transmission Range Selector Cable Replacement - Column

Automatic Transmission Range Selector Cable Replacement - Column

Removal Procedure

1. Set the park brake and chock the wheels.




2. Disconnect the transaxle range selector cable terminal (1) from the transaxle manual shift lever pin.
3. Press the locking tabs inward in order to release the transaxle range selector cable (2) from the bracket.
4. Remove the left instrument panel (I/P) closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Instrument Panel Insulator Panel Replacement - Left Side).




5. Remove the retaining clip from the range selector cable.
6. Remove the range selector cable from the column control lever.




7. Remove the range selector cable from the steering column bracket.
8. Remove the range selector cable through the hole in the cowl.

Installation Procedure




1. Properly route the range selector cable through the engine compartment.
2. Install the range selector cable through the cowl.




3. Install the range selector cable to the steering column bracket.




4. Install the retaining clip to the range selector cable.
5. Install the range selector cable to the column control lever.
6. Install the left I/P closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Instrument Panel Insulator Panel Replacement - Left Side).




7. Install the transaxle range selector cable (2) into the bracket.
8. Connect the transaxle range selector cable terminal (1) to the transaxle manual shift lever pin.
9. Adjust the range selector cable. Refer to Range Selector Lever Cable Adjustment (Adjustments).