95. Oil Pan Installation

Oil Pan Installation




1. Place a 3 mm (0.118 in) bead of RTV sealant on the block pan rail and the crankshaft rear oil seal housing (1). Refer to Adhesives, Fluids, Lubricants, and Sealers ([1][2]Fluid Type Specifications) for recommended sealant.




2. Position the oil pan (1) onto the block.




3. Loosely install the oil pan bolts (1) and (2).

Oil Pan Tightening Sequence:

Caution: Refer to Fastener Caution (Fastener Caution).

4. Tighten the oil pan bolts in sequence shown.

1. Tighten the 8 mm bolts (1-11) to 25 Nm (18 lb ft).
2. Tighten the 6 mm bolts (12, 13) to 10 Nm (89 lb in).