Operation CHARM: Car repair manuals for everyone.

C0456




DTC C0456

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.

DTC Descriptor
DTC C0456 4B
- Steering Position Sensor Calibration not Learned

Circuit/System Description

If the power steering control module is replaced, the calibration needs to be learned to the new power steering control module using a scan tool. If there is no communication with the power steering control module, replace the steering gear.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The calibration is not learned to the new power steering control module.

Action Taken When the DTC Sets

* DTC C0456 is stored in memory.
* The driver information center displays the SERVICE POWER STEERING warning message.
* No Steering assist.

Conditions for Clearing the DTC

The calibration needs to be learned to the new power steering control module using a scan tool, perform the Electronic Power Steering, Special Functions, Steering Angle Sensor Centering procedure.

Reference Information
Schematic Reference

Power Steering Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Power Steering System Description and Operation (Power Steering System)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information

Circuit/System Verification

1. Verify that DTC C0456 4B is not set.

If the DTC is set, calibrate the steering position sensor. Refer to Power Steering Control Module Calibration (Power Steering Control Module Calibration). If the DTC resets, replace the steering gear.

2. Replace the K43 Power Steering Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Steering Gear Replacement (NJ1) (Steering Gear Replacement (NJ1))Steering Gear Replacement (NV7 or N40) (Steering Gear Replacement (NV7 or N40))
* Control Module References (Programming and Relearning)for power steering control module replacement, setup, and programming