Object Detection

DTC B1008

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.

DTC Descriptor
DTC B1008 42
- Calibration Data Not Programmed Calibration Data Set Not Programmed

Circuit/System Description

When the ignition is turned ON, the object alarm module performs a self-test to verify if any critical malfunction exists within the system. During the power-up mode, the object alarm module checks for a valid calibration data set.

Conditions for Running the DTC

* DTC B1325 is not set
* Ignition voltage is between 9-16 volts

Conditions for Setting the DTC

A valid calibration is not detected upon module power-up.

Action Taken When the DTC Sets

* Parking assist is disabled.
* The object alarm module commands the red indicator ON.
* The object alarm module sends a serial data message to the instrument panel cluster (IPC) to display SERVICE PARK ASSIST message in the driver information center (DIC) and a chime will sound.

Conditions for Clearing

* The DTC will transition to history when the fault is no longer present.
* A history DTC will clear after 100 malfunction-free ignition cycles.

Reference Information
Schematic Reference

Object Detection Schematics ([1][2]Collision Avoidance and Parking Assist Systems)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Object Detection Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information

Circuit/System Verification

Verify that DTC B1008 is not set.

If the DTC is set, program the object alarm module. Refer to Object Alarm Module Programming and Setup (Testing and Inspection). If the DTC resets, replace the object alarm module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning)for object alarm module replacement, setup, and programming