46. Reverse Clutch Housing Installation
Reverse Clutch Housing Installation
Special Tools
J 34741-3 - Input Shaft Seal Sizer
For equivalent regional tools, refer to Special Tools (4T80-E - Automatic Transmission).
1. Remove the J 34741-3 - Input Shaft Seal Sizer.
2. Install the reverse clutch housing and the second sprag assembly (500-520) onto the reaction carrier assembly (604). The teeth on the reverse clutch housing must seat into the reaction sun shell. Twist the reverse housing to install and insure proper seating.
3. Install the thrust washer (436) on top of the reverse clutch housing with the tabs pointing down.