53. Turbine Shaft Seal Replacement - Shaft to Case Cover

Turbine Shaft Seal Replacement - Shaft to Case Cover

Special Tools
* J 7079-2 - Universal Driver Handle-Non Threaded
* J 8092 - Driver Handle
* J 39062 - Turbine Shaft Seal Tool
* J 39648 - Drive Sprocket Seal Installer

For equivalent regional tools, refer to Special Tools (4T80-E - Automatic Transmission).




1. Using J 7079-2 - universal driver handle-non threaded (1) and the remover side of the J 39062 - Turbine Shaft Seal Tool (2), remove the case cover to turbine shaft seal (35).




2. Using a small screwdriver, remove the case cover to drive sprocket seal (34) by tapping the seal out through the slots in the case cover.




3. Using J 7079-2 - universal driver handle-non threaded (1) the installer side of the J 39062 - Turbine Shaft Seal Tool (2), install the case cover to turbine shaft seal (35).




4. Using J 8092 - Driver Handle (1) and J 39648 - seal installer (2), install the case cover to drive sprocket seal (34).