Sunroof Window Motor Initialization

Sunroof Window Motor Initialization

Perform the Initialization/Teach Process any time the sunroof motor/actuator is removed from the sunroof.

1. Ensure that the electrical harness on the headliner is connected to the sunroof motor.
2. Re-initialization (Normalization) - Press "Manual Close Switch" for more than 10 seconds, the sunroof's position will not change during the initialization process.
3. Make sure the sunroof window is in the full close position before re-initialization.
4. Learn:

1. Open the sunroof window/sunshade with the express or manual open switch to the full open position then release the switch.
2. Press "Manual Open Switch" for more then 10 seconds or until the sunroof window starts AND reaches the Close Position.

5. Verify the operation of the sunroof.

Note: The Initialization/Teach Process is not complete if any of the following actions take place before the initialization cycle is done:

* The sunroof switch is not held in the close position.
* The ignition and/or battery power has been removed.
* The glass panel has not reached the closed position.

The Initialization/Teach Process must be restarted if the procedure is not carried out completely.