7. Fuel Rail and Injectors Removal

Fuel Rail and Injectors Removal (LAF) (2.4L)

Special Tools

EN-49248 - Fuel Rail Assembly Remover

For equivalent regional tools, refer to Special Tools (Special Tools)




1. Disconnect the electrical harness from the fuel rail harness connection.
2. Disconnect all 4 fuel injector electrical connections.
3. Remove the fuel rail assembly retaining bolts.

Note: Use care to avoid contact with the fuel rail harness during special tool installation and fuel rail removal.

4. Install EN-49248 - studs (1) into the 2 center fuel rail assembly retaining bolt locations. Tighten the studs to 22 Nm (16 lb ft).
5. Install EN-49248 - remover (2) onto each stud, and engage the hooks to the fuel rail. Install the nuts (3) retaining the remover onto the studs and tighten until snug.





Note: EN-49248 will assist in the proper removal of the fuel rail assembly. Ensure that the following conditions are met:

* Turn the handles simultaneously in order to pull the fuel rail straight out along the fuel injector axis.
* DO NOT twist when pulling out on the fuel rail and injector assembly.

6. Using EN-49248 - remover , remove the fuel rail assembly (1).