Manual Transmission Shift Lever and Selector Lever Cable Adjustment

Manual Transmission Shift Lever and Selector Lever Cable Adjustment

Removal Procedure

1. Shift transmission into NEUTRAL.

2. Remove the front floor console cover. Refer to Front Floor Console Replacement Front Floor Console Replacement.





3. Unlock shift lever and selector lever cable adjust locks (1), by pushing back the spring force loaded black sliding ring until self-locking.

4. Unlock the left cable trough the opening at the housing (arrow) using a suitable tool.





5. Slide transmission control lever boot upwards.

6. Press 2 latches (arrows).

7. Slide blue transmission control lever retainer ring (1) upwards.

8. Pull trigger (2) upwards.

9. Remove transmission control lever knob.





10. Turn transmission control lever knob (1) 180 degrees and install to transmission control lever.

11. Push the 2 pins (2) into the 2 holes (3).

12. Remove engine control module from battery tray and lay aside.





13. Block transmission control housing (2) using a 5 mm rod (1).

Installation Procedure





Note:
When locking the adjuster locks (1) a defined snap noise should be audible, a snap effect should be felt.

1. Lock shift lever and selector lever cable adjust locks.

2. Lock shift lever and selector lever cable adjust locks (1), by pushing down the two blue locking pieces WITHOUT touching/preloading the fixed shift lever.





3. Install transmission control lever knob.

Turn the transmission control lever knob back 180°.

4. Press the transmission control lever knob during installation completely down. Push trigger (2) upwards.

5. Slide blue transmission control lever retainer ring (1) downwards.

6. Remove the 5 mm rod from the transmission control housing.

7. Check correct shifting function.

8. If necessary repeat adjusting procedure.

9. Install the front floor console cover. Refer to Front Floor Console Replacement Front Floor Console Replacement.