P0BE6

DTC P0BE6-P0BE8, P0BEE, P0BEF, or P0BF0

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0BE6

-
Drive Motor Phase U Current Sensor Performance

DTC P0BE7

-
Drive Motor Phase U Current Sensor Circuit Low Voltage

DTC P0BE8

-
Drive Motor Phase U Current Sensor Circuit High Voltage

DTC P0BEE

-
Drive Motor Phase W Current Sensor Performance

DTC P0BEF

-
Drive Motor Phase W Current Sensor Circuit Low Voltage

DTC P0BF0

-
Drive Motor Phase W Current Sensor Circuit High Voltage

Circuit/System Description

The generator control module also called the starter generator control module is comprised of the following three control modules; the hybrid powertrain control module, 14 volt power module and the drive motor control module. These three control modules are non serviceable and are part of the generator control module.

This is an internal fault detection of the generator control module. This fault is handled inside the generator control module and no external circuits are involved.

Conditions for Running the DTC

The control module runs the program to detect an internal fault when the drive motor control module is awake and the engine is off.

Conditions for Setting the DTC

* The control module has detected an internal malfunction.

* The motor phase U current is greater than 440 amps or less than -440 amps.

* The motor phase W current is greater than 440 amps or less than -440 amps.

Action Taken When the DTC Sets

* DTCs P0BE6, P0BE7, P0BE8, P0BEE, P0BEF, and P0BF0 are Type B DTCs.

* The generator control module operates in a reduced power mode.

* Regenerative breaking torque is reduced.

* Autostop and electric power assist are disabled.

Conditions for Clearing the DTC

DTCs P0BE6, P0BE7, P0BE8, P0BEE, P0BEF, and P0BF0 are Type B DTCs.

Reference Information

Schematic Reference

Hybrid Energy Storage Schematics [1][2]Electrical Diagrams

Description and Operation

* Starter Generator Description and Operation Starter Generator Description and Operation

* Generator Control Module Description and Operation Generator Control Module Description and Operation

* Hybrid Modes of Operation Description Hybrid Modes of Operation Description

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

If the DTC is set, program the K59 starter generator control module. If the DTC resets, replace the K59 starter generator control module.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

Control Module References Programming and Relearning for Generator Control Module, also called the Starter Generator Control Module, replacement, programming and setup.