Power Locks: Description and Operation

Power Door Locks Description and Operation

Door Lock System Components

The power door lock system consists of the following components:

* Door lock switch, located in the center of the instrument panel

* Rear window/door lockout switch, located on the driver window switch

* Body control module (BCM)

* Driver door latch

* Passenger door latch

* Left rear door latch

* Right rear door latch

* Door lock security PCB relay

Door Lock and Unlock Operation

When a door lock switch is activated in the lock or unlock position, the BCM will receive a ground signal on either the door lock switch lock or unlock signal circuits.

The BCM, upon receipt of a lock switch lock or unlock signal, will supply battery voltage to the door lock actuator lock or unlock control circuits. Since the opposite side of the lock actuator is connected to ground through the other lock actuator control circuit, the doors will then lock or unlock as commanded.

The following three circuits are used to operate the lock:

* Driver door unlock

* Passenger door unlock

* All door lock

The driver door lock actuator is isolated so it can be unlocked by itself using the keyless entry transmitter.

Rear Window and Rear Door Lockout Operation

The operator has the option to disable the interior rear door handles to prevent the unauthorized opening of the rear door doors while still retaining normal driver and passenger door handle functions. The driver door window switch has a lockout switch that will disable the interior rear door handles and the local rear window switches. When the lockout switch is pressed, the BCM will command the child lockout latches and will also send a disable command to the local rear window switches. The driver and passenger doors will still function normally by pressing the central door lock switch which will unlock the doors but the child lockout latches will continue to disable the interior rear door handles.

Pressing the lockout switch again will signal a command to the BCM to unlatch the rear doors, restore normal interior rear door handle functions and restore normal function of the rear window switches

If the lockout indicator flashes while commanding the lockout system, indicates that the BCM has detected a fault in the system and that one or both interior rear door handles are not locked out and/or the local rear window switches are not locked out.