44. Engine Block Assemble

Engine Block Assemble





1. Apply sealant to all plugs (1, 2, 3) prior to installation. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

2. Install the drain plug, with sealant, in the water pump.

Caution:
Refer to Fastener Caution Fastener Caution.

3. Install the coolant jacket plugs, with sealant, and tighten to 35 Nm (26 lb ft).

4. Install the rear oil passage plugs, with sealant, and tighten to 60 Nm (44 lb ft).

5. Install the other oil passage plugs, with sealant, and tighten to 35 Nm (26 lb ft).





6. Lubricate the crankshaft position sensor O-ring with engine oil. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

7. Install the crankshaft position sensor (1) and bolt and tighten to 10 Nm (89 lb in).

8. Install the oil pressure switch (2) and tighten to 26 Nm (19 lb ft).





9. Install the knock sensor (1) and bolt and tighten to 25 Nm (18 lb ft).





10. Install the piston oil nozzle assemblies (1), if equipped.

11. Install the piston oil nozzle assembly bolts and tighten to 15 Nm (11 lb ft).