Electronic Brake Control Module: Testing and Inspection
Electronic Brake Control Module Programming and Setup
The following service procedures require either a programming or a setup event performed for a complete repair.
Electronic Brake Control Module Replacement
If the electronic brake control module (EBCM) needs to be replaced, the following procedures must be performed:
1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).
2. Perform the SPS function Electronic Brake Control Module-Programming and follow the on-screen instructions.
3. Perform the SPS function Electronic Brake Control Module-Setup and follow the on-screen instructions. Setup and follow the on-screen instructions.
4. Clear DTCs after completing the programming procedure.
Electronic Brake Control Module Reprogramming
If the EBCM needs to be reprogrammed, the following procedures must be performed:
1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).
2. Perform the SPS function Electronic Brake Control Module-Programming and follow the on-screen instructions.
3. Clear DTCs after completing the programming procedure.